AcrEase Pull-Behind Mowers for John Deere Gator

Last updated: September 30, 2026. Prices update automatically from our live catalog.

A John Deere Gator and a Kunz AcrEase mower make a capable pair for pasture, trail, and property work. John Deere lists an integrated 2-inch rear receiver on the Gator XUV 590M, XUV 845, and XUV 825M S4 / 855M S4, with tow ratings of 1,500 lbs and up. Kunz lists AcrEase mowers at 235 to 580 lbs. Traditional Gators need a closer look: the TX uses a 1.25-inch receiver, and the electric TE is rated to tow 500 lbs, which limits it to the lightest AcrEase.

Every AcrEase Model, Current Pricing

The models below tow behind most current Gators; see the chart that follows for TX and TE limits. Prices in this table update automatically from our live catalog, and each model links to its product page.

Which Gator, Which Mower

John Deere specs for current Gator models. Pick the mower for your ground and acreage, and stay within your Gator's tow rating.

Weights are from Kunz: MR44 series 520 to 530 lbs, MR55 series 580 lbs, Pro60 series 560 lbs, and H40B 235 lbs.

Hitch and Tongue Setup

AcrEase rough cut mowers use a standard farm clevis, a C-shaped coupler that Kunz says gives "excellent freedom of motion in all directions." On an XUV, slide a 2-inch receiver drawbar with a pin hole into the integrated rear receiver and drop the clevis pin through it. On a Gator TX, use a 1.25-inch drawbar with a pin hole. Skip the ball: Kunz notes a ball hitch is restricted to 12 degrees of motion side to side and up and down. The tow bar can be set to pull directly behind or fully offset to the side of the tow vehicle.

For the finish cut line behind a Gator, Kunz pairs its finish cut mowers with the optional ATV tongue, which hitches to the tow vehicle's existing hitch with a provided clevis pin. We stock the UTV tongue assembly for the H40B and the UTV/ATV tongue assembly for the Pro60K. For Pro60B and Pro60KWE tongue setup, call 877-203-4939 and we will confirm the right configuration.

Rough Cut or Finish Cut

Rough cut (MR44 and MR55 series) is for overgrown fields, pastures, trails, food plots, and light brush. Kunz builds them with 10-gauge decks, two blades, and a belt drive, with a conservative 2-inch sapling rating. Finish cut (H40B and Pro60 series) is for maintained grass where cut quality matters, such as large lawns, parks, and the acres around the house. Kunz puts rough cut mowing speed at 4 to 10 MPH and finish cut at 6 to 10 MPH in normal conditions. Full comparison on the Rough Cut & Finish Cut Mowers page.

John Deere Gator Notes

• Differential: John Deere lists a lockable rear differential on the XUV 590M and a switch-activated locking rear differential on the XUV 845. Keep the rear lock off on grass unless you need extra traction; a locked rear axle scuffs turf in tight turns.
• Gator TE: John Deere rates the electric TE to tow 500 lbs. The H40B finish cut mower (235 lbs) is the only AcrEase under that rating.
• Slopes: Kunz rates Kohler and Briggs & Stratton Commercial Turf engines for slopes up to 25 degrees, and says Briggs & Stratton Professional and Intek engines should not run on angles over 20 degrees for any length of time. Kunz also notes most tow vehicles become unstable after 20 to 25 degrees.
• Useful add-ons: the 44" and 57" electric lift kits raise and lower the deck from the driver's seat, the wetlands kit is built for marshy ground, and the hour/tach meter keeps maintenance on schedule.
• Outfitting the whole machine: browse John Deere Gator accessories.

Frequently Asked Questions

Can a John Deere Gator XUV pull a 57 inch rough cut mower?

Yes. Kunz lists the 57" MR55 series at 580 lbs. John Deere rates the XUV 590M and XUV 825M S4 to tow 1,500 lbs and the XUV 845 up to 4,000 lbs in low gear.

Can a Gator TE pull an AcrEase?

Only the H40B finish cut mower, which Kunz lists at 235 lbs. John Deere rates the TE to tow 500 lbs, below the weight of every other AcrEase model.

Do I need a ball hitch?

No. AcrEase rough cut mowers use a farm clevis. Use a receiver drawbar with a pin hole: 2-inch on XUV models, 1.25-inch on the Gator TX. Kunz notes a ball hitch limits the coupler to 12 degrees of motion.

Are AcrEase mowers PTO-driven?

No. Every AcrEase carries its own engine; the Gator only pulls it.

Manual or electric clutch?

Electric clutch models engage the blades with a switch, so you can start mowing from the seat. Manual clutch models carry a lower price.

Ready to Mow?

Questions on sizing or setup? Call 877-203-4939 (Mon-Fri 9am-4pm MST) or start with the AcrEase shopping guide. Kubota owners can see AcrEase mowers for Kubota RTV. Polaris owners can see AcrEase mowers for Polaris Ranger. Browse everything Kunz at Kunz Pull-Behind Mowers.