Snow Plow Kits and Tracks for CFMOTO UFORCE

Last updated: October 1, 2026. Prices refresh daily from our catalog.

Getting a CFMOTO UFORCE ready for winter usually comes down to two upgrades: a plow to move snow, and tracks to keep moving through it. We carry both. Below you will find 7 KFI snow plow kits listed by CFMOTO UFORCE model and year and 10 Camso UTV 4S1 track kits, along with the manufacturer specs that matter when you choose.

KFI Snow Plow Kits for CFMOTO UFORCE

Each KFI kit we sell is a complete system built around the vehicle-specific mount KFI calls out for that machine. A kit includes:

• Vehicle-specific plow mount matched to your CFMOTO UFORCE model and year.
• KFI PRO 2.0 push tube (#106300). KFI lists it as a front-mount design with 30 inches or more of lift height, six blade pitch adjustments of 5 degrees each, and three angle positions that rotate the blade up to 25 degrees. It is built from 1-1/2 inch, 12-gauge square steel tubing, carries a 2-year KFI warranty and is made in the USA.
• Your choice of blade: KFI Pro-S steel or Pro-Poly, in 60, 66 or 72 inches.
• Plow strap, mounting hardware and instructions. A KFI winch can be added on the product page.

Pro-S Steel or Pro-Poly Blade

By KFI's numbers, the Pro-Poly has the taller face, and the Pro-S steel blade is the lighter one in every width with a lower KFI list price.

Lifting the Plow

KFI's PRO 2.0 push tube instructions say the system needs a winch to raise and lower the blade. KFI also makes the ACT203 electric-over-hydraulic actuator as an alternative to a winch; it is sold separately with its own bracket and wiring harness. KFI's manual says not to exceed 5 MPH, even with the blade raised, and never to stand or ride on the plow.

Every KFI Plow Kit We Carry for CFMOTO UFORCE

Prices shown are the kit's starting price; the final price depends on the blade and options you choose on the product page.

Camso UTV 4S1 Tracks for CFMOTO UFORCE

The Camso UTV 4S1 is Camso's all-season track system for side-by-sides from 400 to 1000cc. Each kit includes four track systems (two front, two rear) and the mount kit adapted to your vehicle. Camso's published specs:

• Ground contact: about 2,520 square inches.
• Ground clearance: about 5 inches more than stock tires.
• Track width: 12.5 inches front, 14 inches rear.
• Weight: 103 lbs per front system and 120 lbs per rear system, plus the mount kit.
• Camso's capability claims: climb 20 degree hills, handle 20 degree sidehills, haul up to 1,000 lbs of supplies in deep snow, and tow a 2,500 lb ice shack at up to 15 MPH across ice and snow.

From Camso's UTV 4S1 owner's manual: the system is designed for a maximum real speed of 40 km/h (about 25 MPH), tracks change speedometer and trip meter readings by about 35 percent, the vehicle should always run in 4x4 mode, and the first 4 hours or 80 km should be a break-in period on wet or lubricated ground such as snow, mud or water. The warranty runs 24 months from the date of purchase.

Every Camso UTV 4S1 Kit We Carry for CFMOTO UFORCE

Running a Plow and Tracks Together

Tracks raise the machine, which changes where the plow mount sits relative to the ground. KFI notes that lifted machines, larger tires and tracked machines may need extra KFI parts so the plow sits and lifts correctly. Each KFI kit page above asks two questions so you can add them in one order:

• Does your machine have tracks? Choose yes to add the KFI UTV tracks extension bracket (KF-106330).
• Does your machine have a lift kit? Choose yes to add a KFI leveling kit for a 1 to 2 inch lift.

If you plan to run Camso tracks and a KFI plow on the same CFMOTO UFORCE, call 877-203-4939 and we will check the mount, bracket and lift setup for your model.

Summer Use

Looking for a project once the snow melts? See our guide to AcrEase pull-behind mowers for the CFMOTO UFORCE.